Flooring Services in chevy chase
- Hardwood refinishing: We sand down to bare wood, then stain and seal. This removes the scratches, gray traffic lanes and pet wear that build up over the years
- Screen and coat: For floors that look dull but aren’t damaged, we buff the existing finish and apply a fresh topcoat. It’s a quicker, lower-cost way to bring back the shine.
- Repairs: We cut out and replace boards damaged by water, termites, pet urine or deep gouges, then blend them into the surrounding floor.•
- Installation: Solid hardwood, laminate, LVT and LVP, with help choosing the right material for each room.
Chevy Chase Homes We Work In
Much of Chevy Chase was developed in the early 1900s, and homes from that period often have narrow-strip oak floors that have been refinished several times over the decades. Every sanding takes off a little wood, so these floors call for a lighter touch. Before we start, we check how much wood is left above the tongue and recommend either a full refinish or a screen and coat. When an addition or kitchen renovation needs new flooring, we work to tie it into the original floors so the house still reads as one home.
Neighborhoods We Serve
Chevy Chase Village, Town of Chevy Chase, Section 3, Section 5, Martin’s Additions, Rollingwood, Somerset and Kenwood. ZIP code 20815.
Frequently Asked Questions
My floors have been refinished many times. Can they take another sanding?
Often they can, but it depends on how much wood is left. We’ll pull a floor register or check an edge to measure. If the floor is getting thin, we’ll recommend a screen and coat or targeted board replacement instead of a full sand.
Can you match boards in an older house?
We match species, width and stain as closely as possible. When original boards can be salvaged from a closet or another area, that’s often the best match for a repair in a visible spot.
